technoCASE - Multivariable enclosures made of ABS

Technical data

Enclosure	ABS halogen free or Polycarbonate -50°C up to +120°C halogen free, on request. 1° mould slope for casting ejection.
Lid screws	Captive screws made of stainless steel 1.4567.
Ingress protection	IP 66 EN 60529
Surface resistance	ABS: 4 x 10¹⁴ Ohm Polycarbonat: 10¹⁵ Ohm
Combustion behaviour	HB – UL 94
Insulation	Fully insulated VDE 0100.
Gasket	Designed gasket, made of silicon (-40°C up to +120°C).
Colour	Light grey, similar to RAL 7035 Special material on request.
Fastening	Separate screw channels outside the enclosure interior. For additional options refer to accessories.
Internal mounting	There are many mounting points for self-grooving fasteners available within the enclosure bottom, as well as in the lid.
Use our service	Ready for installation from ROLEC